ADM7008 |
RFQ for ADM7008 Required Field |
 |
| Technical/Catalog Information | ADM7008A3T1 |
| Vendor | Infineon Technologies |
| Category | Integrated Circuits (ICs) |
| Controller Type | Ethernet Switch Controller |
| Interface | Serial |
| Voltage - Supply | 3 V ~ 3.6 V |
| Current - Supply | - |
| Package / Case | 128-PQFP |
| Packaging | Tray |
| Operating Temperature | - |
| Lead Free Status | Contains Lead |
| RoHS Status | RoHS Non-Compliant |
| Other Names | ADM7008A3T1 ADM7008A3T1 |
| Product | Manufacturers | Pack | D/C |
| ADM7008 | - | INFINEON | 06+ |
ADM7008 integrates eight 100Base-X physical sublayer (PHY), 100Base-TX physical medium dependent (PMD) transceivers, eight complete 10Base-T modules into a single chip for both 10 Mbits/s and 100 Mbits/s Ethernet operation. It also supports 100Base-FX operation through external fiber-optic transceivers. The device is capable of operating in either full-duplex mode or half-duplex mode in either 10 Mbits/s or 100 Mbits/s operation. Operational modes can be selected by hardware configuration pins, software settings of management registers, or determined by the on-chip auto negotiation logic.
Features |
| • IEEE 802.3 compatible (2000 edition) 10BASE-T and 100BASE-T physical layer interface and ANSI X3.263 TP-PMD compatible transceiver.• Eight-port, single chip, integrated physical layer and transceivers for 10BASE-T and 100BASE-TX function.• Reduced MII (RMII), Serial MII (SMII) and Source Synchronous MII (SS_SMII) for high port count switch.• Built-in 10Mbit transmit filter.• 10 Mbit PLL, exceeding tolerances for both preamble and data jitter.• 100Mbit PLL, combined with the digital adaptive equalizer and performance exceeds 140 meters for UTP 5.• 125MHz Clock Generator and Timing Recovery.• Integrated Base Line Wander Correction.• Carrier Integrity Monitor function supported.• Supports FEFI when Auto Negotiation is disabled.• Supports Auto Cross Over Detection function for Plug-and-Play.• IEEE 802.3u Clause 28 compliant auto negotiation for full 10 Mbps and 100 Mbps control.• Supports programmable LED for different Switch Application and Power On LED Self Test.• Supports Cable Length Indication both in MII Register and LED (Programmable).• Supports Cable Broken Auto Detection function and indicate cable broken location.• Supports PECL interface for fiber connection.• Built-in 3.3V to 1.8V Regulator Control Signal.• Built-in Clock Generator and Power On Reset Signal to save system cost.• 128 PQFP with 1.8V/3.3V Power Supply.• Support Power saving function.• Support Parallel/Serial LED output. |
